操作步驟：
速度控制器和電機接好后，接上AC電源，當控制器按鈕調至RUN，從電機軸方向看，電機順時針方向旋轉。但是電機和減速機的旋轉方向是否一致，取決于減速比，請看每種配置與詳細參數。

不同的速度：
基本型的速度控制器速度旋鈕順時針旋轉，電機轉速增加，反之電機轉速減少，調整范圍90-1350rpm.

關閉
將開關按鈕指向STOP，電機運轉停止，此按鈕不是電源的開頭按鈕，需要長時間停止運轉時，請另外設置電源開關。

Operation
The speed control unit and the lead wire connector of the motor are connected and then teh plug cord is conected to AC power. When the RUN/STOP switch of the control unit is switched to RUN, then it is turn clocdwise, (The product is made so that it will rotate in the clockwise direction. Howeve, at times, due to gear ratio the direction of rotation for the gearhead shaft is opposite (counter-clockwise)).
Variable Speed
If the SPEED VOLUME switch of the control unit is turned turned number of rotation of the motor increases and if it is turned counter-clockwise, slows down.
It is possible to control and designate the speed of the motor between90~1350rpm.
Stop
If the RUN/STOP switch of the control unit is switched to STOP,the motor stops. This switch is not an on-off switch for power. When the motor nedds to be stopped for a long time, a separate power source should be installed and turned off.